Cold Saw/V1 Design Files/Shaft Block

Shaft Block

• Length: 76.2mm

• Width: 50.8mm

• Height: 100mm

• Shaft Hole Diameter: 31.8mm

• Shaft Hole Spacing Along Length: Centered

• Shaft Hole Spacing Along Height: 65mm

• Mount Hole Diameter: 10.5mm then M12x1.75 Tap

• Mount Hole Depth: 50mm

• Mounting Rectangle: 30mm x 55mm

• Mount Rectangle Spacing: Centered

• Stopper Adjustment Hole: 10.5mm DIA, then M12x1.75 Tap with 20mm DIA 13mm Depth Counterbore

• Stopper Adjustment Hole Depth: 60mm

• Height Notes: If the Shaft Block is high, rigidity decreases but the shaft can be placed at a higher point- in which case the blade's arc of travel (between the bottom stop and the closest contact point with the clamping volume) has a lower horizontal difference. In this case, the function of the horizontal difference for different height values of the Shaft Block reveals that the change is low enough to justify higher rigidity over higher centering versatility.

• 2D Image

• 3D CAD STP

File:ColdSawV1ShaftBlock.stp

• 2D Fabrication Drawing PDF

File:ColdSawV1ShaftBlock.pdf

• 2D Fabrication Drawing DXF

File:ColdSawV1ShaftBlock.dxf