modified pivot plates with rounded part shortened
All holes increased by 1/16" to 1-1/8" to facilitate bolting
.dxf file showing the 30 holes on 4" centers that appear in a 10' 4x4 tube
The wheel mount plates are also modified per previous discussions, i.e. Holes for option of direct bolting to the 4x4s. The plates that the motor is bolted to were completely incorrect (MJ note: incorrect only if Motor Interface plate is not used, which it isn't) to accommodate the 45.6 Cu In Motors. I made the corrections and made a new .dxf file (attached).

Marcin, please confirm this order and let Katie know:

[48] pieces of 1/2"x8"x16" mild steel plate - Stock Bonding Plate. Note bolt holes are 1-1/8" - intended for 1" bolts.Weight - 17.8 ea or about 855 lb total.
[25] pieces of nominal 1/2"x8"x16" mild steel plate - (Modified) Stock Pivot Plate. Note bolt holes are 1-1/8" - intended for 1" bolts. About 385 lb.
[20] pieces of 1/4"x4"x4" square tubing - 10' long. 400' total. Note bolt holes are 1-1/8" - intended for 1" bolts, every 4" on center, first hole at 2" from the end on center. Total weight about 2660 lb.

quick attach wheel mount plates for the 1 7/8" shaft size

LifeTrac 6 Parts Order