File:D3DLulzbotCura.ini

From Open Source Ecology
Revision as of 18:20, 16 June 2017 by Marcin (talk | contribs) (File version from testing of 6/11/17. Overrides extruder steps to 100/mm Turns heat off upon ending. Are absolute coordinates necessary? The Z offset from extruder is in question here. Here it is commented out. start.gcode = M92 E100 ; Extruder...)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

D3DLulzbotCura.ini(file size: 10 KB, MIME type: text/plain)

Warning: This file type may contain malicious code. By executing it, your system may be compromised.

File version from testing of 6/11/17. Overrides extruder steps to 100/mm Turns heat off upon ending. Are absolute coordinates necessary? The Z offset from extruder is in question here. Here it is commented out.

start.gcode = M92 E100  ; Extruder steps per mm set to 100 M203 Z10  ; override max Z feedrate from 5 to 10 mm/s G28 X0 Y0 Z0  ; home G29  ; autolevel G90  ; set absolute coordinates ;M851 Z-2  ; Set the Z probe offset to -2 end.gcode = G28 X0 Y0 ;move X/Y to min endstops M84 ;steppers off M104 S0  ; make sure the extuder is turned off. M140 S0  ; make sure the bed is turned off.

File history

Click on a date/time to view the file as it appeared at that time.

Date/TimeDimensionsUserComment
current18:20, 16 June 2017 (10 KB)Marcin (talk | contribs)File version from testing of 6/11/17. Overrides extruder steps to 100/mm Turns heat off upon ending. Are absolute coordinates necessary? The Z offset from extruder is in question here. Here it is commented out. start.gcode = M92 E100 ; Extruder...

The following page uses this file: