D3D v18.07

Development Template

edit

Shakedown Checklist

Prior to Turn-On

Do not plug the 3D printer into a wall outlet yet.

1. Verify power plug to power supply is ground, +, neutral/
2. Plug in RAMPS green plug to - + - + in that order from the left of green plug looking at the control panel.
3. Verify that the LCD is plugged in correctly - plug 1 and 2 as labeled
4. Plug in USB cable to computer
5. When USB cable is plugged in, LCD lights up daying OSE D3D Printer ready. This assumes the firmware is already on the controller board.

• Plug in

• Verify axis motion
• Verify all printing parameters - G_Codes#Status_Codes
• Make sure print profile (.ini file) is correct)