3D Printer End Stops
Jump to navigation
Jump to search
Testing
- To Test the endstops, use command line in Lulzbot Cura - [1]
- RepRap says you want to use a Normally Closed (NC) switch. This is reasonable if a cabling break means that you trigger and cannot go on until you fix the cable break. NC prevents a runaway condition.
- Wiring instructions from another site - [2]
Working Doc
Links
- 3D Printer Genealogy - for all the prototypes built. These are the main trunk and branches of OSE's Universal Axis-based 3D printer.