Angle Frame Connector

Build

CAD

• 

  Angle Connector. - FreeCAD with McMaster 6 mm nut -File:Angleconnector.fcstd. Finished STL - File:Anglecorner.stl

• 

  Angle Connector. - FreeCAD - File:Leftcorner.fcstd. Finished STL - File:Leftcorner.stl

• 

  Angle Connector. - FreeCAD - File:Rightcorner.fcstd. Finished STL - File:Rightcorner.stl

Concept

edit

Production

• 50% infill for real print.
• Test print at 20%: 10 cm cut off the bottom, standing on corner - . This would not stand on moving-bed printers. Babystepping correction -0.75. It does not stand on a stationary bed printer eiether. I turned it around to print standing on 6 points.

• Came off bed so printed it on 6 corners:

• Initial fit: metal shown with 6 mm hex nut and set screw in the hole.

• STL - sunk 5 mm into bed. Test print at 20%, takes 8.5 hrs. Production print: 50% infill, 10:10 hours, 133 g. Brim 10 lines. Prints starting on 6 corners, for a solid base.