Marlin Bed Temperature Overshoot

Data

• SSR - 5 hz max reliable switching frequency. [1]. 0.5 hz recommended for heating.
• Overshoot is 10-30C on the bed. D3D_v20.04.27_Data_Collection#Hysteresis_of_Bed

Code

M303 S50 E-1 C5 - 5 passes, set for 50C, -1 for bed

Procedure

PID Autotune - [2]

Results

Extruder

Using Lulzbot Cura, M303 with no parameters heats the extruder to about 150. Each time division is about 30 seconds:

And produces optimal values of P, I, D

M503 displays current values:

< M503

...

< echo:PID settings:

< echo: M301 P22.20 I1.08 D114.00

You can save the values from PID Autotune by going into configuration.h

Bed

• PID autotune would have to be enabled for the bed in configuration.h.
• If one is using an SSR, can this be used with default switching frequency of Marlin? Let's look inside Marlin - Configuration.h
• SSR heats up when conducting via voltage drop. The switching doesn't cause much heat. [3]. See SSR Lifetime. It is not clear if fast switching (only 8 hz) reduces lifetime over say 4 hz in PWM switching?
• Start by turning on PID for the bed: uncomment #define PIDTEMPBED in configuration.h
• SOFT_PWM - sets PWM frequency?
• Can also add PID autotune to menu: //#define PID_AUTOTUNE_MENU // Add PID Autotune to the LCD "Temperature" menu to run M303 and apply the result. But does this save the result?

Links

• Marlin - PID autotune - [4]