Senville Aura
Jump to navigation
Jump to search
Installation
Notes
- It is not clear whether tubing can be left coiled - [1]. Install manuals say so - one of the diy systems with precharged line sets there instructions specifically state to coil the excess at the system. - but author speculates that since lubricating oil is also carried with refrigerant, there could be an issue.
- This link says coiling is ok (see comments) [2]
- Manufacturers state it is ok. Installers say 'install it properly by cutting to size'. Who do you trust? [3]
- 5-10' coiled - works 3 years running [4]. Other guys in same thread say that coiling will fail after some time. If coiled, lay them out horizontally.
- Summary - shorten line set and adjust charge. Coiling may work according to manufacturer. Interpretation - if manufacturers say it's ok, it should be ok because if they misled the public, they would go out of business. Assuming manufacturers have integrity, we are ok. [5]
- First principle calculations say - Say there is 8 feet of coil left.
Key Videos
- Point - disconnect vacuum After filling up low pressure side with 1 PSI of refrigerant- [6]
- 1 lb? Not 1 atm? Under 1 lb, 14 psi of atmosphere would mean that air actaully leaks into the tubing.
- Note that instructions say to 'let in refrigerant for 5 seconds with quarter turn of valve' - steps 9-10 on page 30 of manual [7]. This is not correct - we should look at the actual valve, no? Video says 1 lb - also not correct. The right way should be to look at the valve, not by time - but by when valve reads a little above atmospheric pressure of 14 psi.
Manual
R-410A - Refrigerant
- https://www.rses.org/assets/r410a/R-410A.PDF
- Pressure-Temperature chart is shown at end of PDF above
Build Pictures
Specs
Heat pump for heating and cooling that works down to -20F. 7kW of heat.
Mounting Bracket
- $70 - [9]
Troubleshooting
- Vacuum doesn't draw down - [10]