Talk:Markless Design

What would be the advantage of this over Laser Level assisted markup, with no visible markup after Drywall Finishing + Paint etc?

GRANTED in terms of Prefabrication of Materials (Pre-Cut+Bent Conduit, Pre-Cut to Length Wires, Pre-Cut Lumber, Pre-Cut Plumbing etc) and (Semi-) Automation of Markup (ie prints are very good, if prefab markup is already done to the pile of materials/kit, etc) i can get it 100%.

Is the concept basically make it like a Lego kit / Ikea Table etc where everything is preformed and all you need to do is just match the Language Agnostic Instructions as you go?

--Eric (talk) 09:43, 12 February 2026 (UTC)