Revision as of 17:32, 5 February 2016

Source of Kit

The main improvement that we will make is adding automatic bed leveling.

Note: correction needs to be made based on the top 2 posts here - on end stop plug in location and change in firmware. [2]. This Github note [3] appears to say the same thing. Further, the first link also states that the firmware is outdated - outside of hte xmax issue mentioned.
Upgrade firmware, including auto bed level with inductive sensor - [4]
Anti-backlash nut case and belt tensioner - [5]
Improvements on Thingiverse - auto level, cable chain, endstop improvements, etc. - [6]
X endstop replacement - [7]

Reddit thread on building FPi3 - [8]
Github Community Folgertech Prusa i3 documentation - [9]. No alignment procedure mentioned.

What settings are adjusted in the firmware, and what settings are adjusted in the software?

@@ Line 28: / Line 28: @@
 *Reddit thread on building FPi3 - [https://www.reddit.com/r/Reprap/comments/42vpku/i_recently_ordered_a_folgertech_prusa_i3_2020_and/]
 *Github Community Folgertech Prusa i3 documentation - [https://github.com/cyberkni/FolgertechManuals/blob/master/2020i3/README.md]. No alignment procedure mentioned.
+=Software/Firmware=
+*'''Firmware''' - Marlin, uploaded via Arduino IDE interface
+*'''Software''' - on host computer - Repetier
+What settings are adjusted in the firmware, and what settings are adjusted in the software?
 =Links=
 *[[XM Prusa i3 Procedure]]