D3D 1612 Software: Difference between revisions
Jump to navigation
Jump to search
(→Cura) |
|||
| Line 8: | Line 8: | ||
=Cura= | =Cura= | ||
* | *Open up Lulzbot Cura. | ||
*Cura already has the initialization profile on OSE Linux. If you are running it on a non-OSE Linux operating system, download [[D3D_Lulzbot_Cura#Configuration_Profile_-_Files]] | |||
=Known Error Messages and Solutions= | =Known Error Messages and Solutions= | ||
*If you get a COM1 error in the Arduino monotor - go to Tools/Port and select the correst USB port. | *If you get a COM1 error in the Arduino monotor - go to Tools/Port and select the correst USB port. | ||
Revision as of 01:14, 9 January 2018
Firmware
- Download D3D_Marlin#D3D_16.22_Frame_12.22_Bed
Arduino IDE
- Upload firmware software after connecting to RAMPS controller
- Select Arduino Mega from Tools/Board. Select appropriate USB port from Tools/Port.
- After software is done uploading, quit out of Arduino IDE and open up Cura
Cura
- Open up Lulzbot Cura.
- Cura already has the initialization profile on OSE Linux. If you are running it on a non-OSE Linux operating system, download D3D_Lulzbot_Cura#Configuration_Profile_-_Files
Known Error Messages and Solutions
- If you get a COM1 error in the Arduino monotor - go to Tools/Port and select the correst USB port.