D3D 1612 Software: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 3: | Line 3: | ||
=Arduino IDE= | =Arduino IDE= | ||
*Upload [[ | *Upload firmware from section above - after connecting [[USB B Connector]] to RAMPS controller | ||
*Firmware includes geometrical properties of the 3D printer - such as settings for the print bed size, location of probe, location of endstops, etc. | *Firmware includes geometrical properties of the 3D printer - such as settings for the print bed size, location of probe, location of endstops, etc. | ||
*Select Arduino Mega from Tools/Board. Select appropriate USB port from Tools/Port. | *Select Arduino Mega from Tools/Board. Select appropriate USB port from Tools/Port. | ||
Revision as of 01:19, 9 January 2018
Firmware
- Download D3D_Marlin#D3D_16.22_Frame_12.22_Bed
Arduino IDE
- Upload firmware from section above - after connecting USB B Connector to RAMPS controller
- Firmware includes geometrical properties of the 3D printer - such as settings for the print bed size, location of probe, location of endstops, etc.
- Select Arduino Mega from Tools/Board. Select appropriate USB port from Tools/Port.
- After software is done uploading, quit out of Arduino IDE and open up Cura
Cura
- Open up Lulzbot Cura.
- Cura already has the initialization profile on OSE Linux. If you are running it on a non-OSE Linux operating system, download D3D_Lulzbot_Cura#Configuration_Profile_-_Files
Known Error Messages and Solutions
- If you get a COM1 error in the Arduino monotor - go to Tools/Port and select the correst USB port.