FeF Microfactory

Production Equipment

Hint: Note that bed size must be set under Machine Settings in Cura - it is not saved in the printer profile. Note also that Start Gcode has the Extruder steps per mm - OSE extruder is different than the Titan Aero

• Babystepping Correction Data. Settings Data.
• D3D v19.06 1 - File:D3d1906 1.ini. 0.4 mm nozzle. Note: bed temp at 60C for PLA using new heated bed heater element.
• D3D v19.06 2 - File:D3d1906 2.ini. 0.4 mm nozzle.
• D3D v19.06 3 - File:D3d1906 3.ini. 0.4 mm nozzle.
• D3D v19.06 4 - File:D3d1906 4.ini. 0.4 mm nozzle.
• D3D v19.06 5 - File:D3d1906 5.ini. 0.4 mm nozzle.
• D3D v19.11 6 - File:D3d1911 6.ini. 0.4 mm nozzle.
• D3D Universal 7 - File:D3duniversal 7.ini. 0.6 nozzle. Note change in M92 to E100
• D3D Universal 8 - File:D3duniversal 8.ini. 1.2 nozzle. Plotter -File:D3duniversalplotter.ini

Production Settings Notes

1. Take bed down 330mm - works for 13" frames

Typical File

Typical Profile File for v19.06

Data Collection

• Using short idler for Z axis may have issues with tilt. Using a full carriage allows for a more constrained vertical orientation
• Side to side tilt of Bed adjustability (not needed) can be eliminated by using a stiff attachment of bed mount to Z carriage. Point of adjustment eliminates final build time.
• Front to back tilt of Bed can be eliminated by equivalent bottoming out of Z axis. Make sure this happens for perfected bed leveling
• Stiff connection of Y to X eliminates any potential loosening of X axis, and eliniates extra interface parts. This facilitates build time, but adds 2 custom parts.

Production Engineering Notes

• When bed temp is above 80C for the printers - the prints do not stick! At 120C, prints fail by coming off the platform.