D3D v20.04 Data Collection: Difference between revisions
Jump to navigation
Jump to search
| Line 11: | Line 11: | ||
=Bed Weight Holding Capacity= | =Bed Weight Holding Capacity= | ||
*From [[D3D v20.04 Calculations]], bed is | *From [[D3D v20.04 Calculations]], bed is 12 lb, and we should be able to lift a total of 40 lb withe the stepper motors - so an additional 25 lb. | ||
*Weight of 1/8" steel plate, 8x8" - 2.3 lb. 10 or 11 of these should be held up. | *Weight of 1/8" steel plate, 8x8" - 2.3 lb. 10 or 11 of these should be held up. | ||
**3 could be held up reliably. So 7 lb of print mass - 3 spools of filament. | **3 could be held up reliably. So 7 lb of print mass - 3 spools of filament. | ||
Revision as of 18:23, 7 May 2020
Stepper Drivers
- DRV 8825 is used for more current on Z. [1]
- Initially, one side motor on Z was 44 mm long (17PM-K402-P4V Minebea Motor Mfg Corp, V and A not shown), and the other was 48 mm long (17PM-K402-P5VS, 3.9V 1.3A). *Small motor was easy to stop - pound or 2, whereas larger motor was more like 10lb to stop.
Heating Time
- Extruder - at 11C from 11C to 230C - 2:15
- Bed - 2:47 at 11C from 11C-100C, 20C hysteresis at top
Physical
- Print volume - 12x12x10 inches - 1440 cu in - or 24 lb max weight of print. Bed can be lowered to attain 12x12x11 or more print volume.
Bed Weight Holding Capacity
- From D3D v20.04 Calculations, bed is 12 lb, and we should be able to lift a total of 40 lb withe the stepper motors - so an additional 25 lb.
- Weight of 1/8" steel plate, 8x8" - 2.3 lb. 10 or 11 of these should be held up.
- 3 could be held up reliably. So 7 lb of print mass - 3 spools of filament.
- Up to 6-7 could move up a little, but then they slammed down once the DRV8825 got hot.