Latest revision as of 22:59, 17 September 2020

Data Collection

1 small 3" zip ties hold a belt teeth together for 12 lb
2 small 3" zip ties hold a belt (teeth together) for 29 lb
With 10 mm long m6 set screw, belt peg 17:29, 14 August 2020 holds the belt, using 2 zip ties in addition - to the 29 lb above. Didn't want to break the scale going higher.
Zip tie orientation - point them both the same way so they fit in the belt hole of the carriage piece.

Click on a date/time to view the file as it appeared at that time.

	Date/Time	Dimensions	User	Comment
current	22:59, 17 September 2020	(40 KB)	Marcin (talk \| contribs)	Lengthened by 4 mm for bottom Z axis evenness.
	21:41, 29 August 2020	(29 KB)	Marcin (talk \| contribs)	Plugged up so it's easier to screw in a set screw.
	01:43, 15 August 2020	(22 KB)	Marcin (talk \| contribs)
	22:29, 14 August 2020	(21 KB)	Marcin (talk \| contribs)	Smaller thruhole, square hole through one side only.
	01:23, 14 August 2020	(24 KB)	Marcin (talk \| contribs)	Round version for m6 bolt center.
	22:17, 13 August 2020	(10 KB)	Marcin (talk \| contribs)

You cannot overwrite this file.

The following 3 pages use this file:

@@ Line 1: / Line 1: @@
+=Data Collection=
+*1 small 3" zip ties hold a belt teeth together for 12 lb
+*2 small 3" zip ties hold a belt (teeth together) for 29 lb
+*With 10 mm long m6 set screw, belt peg '''17:29, 14 August 2020''' holds the belt, using 2 zip ties in addition - to the 29 lb above. Didn't want to break the scale going higher.
+*Zip tie orientation - point them both the same way so they fit in the belt hole of the carriage piece.