Charcoal Washing Experimentation

Basics

• This page documents various "hands on" expirementation by OSE Developers on Charcoal Washing (not to be confused with Activated Charcoal )

By User: Eric

3/15/2021

• Had a "traditional campfire" last night
• Consisted Mainly Of:
  • RDF (paper and "dryer lint" as starters) (small overall, not measured)
  • Forestry Residues ( Southern Pine pinecones, "twigs" , and dropped ~3cm or so branches
  • Crape Murtle pruning branches (still very "green" so lots of sap/smoke/steam)
• This was run until there was only a near homgoenous (due to stirring in the "final stage") Bottom Ash (Powder) + Charcoal (~1cm chunks + smaller dust) mixture
• The following day ~5 spoonfuls of the mixture was added to 500ml of tap water (was massed as well (on a kitchen scale in grams (1 or 2 decimals), grab data from photos) ) so nothing TOO scientific, but should get some data
• The resulting mixture was stirred and agitated with the same "disposable plastic spoon" for ~5 minutes
• Solution Seemed Saturated with entrained charcoal/non-soluable minerals entrained, but this is pending further analysis
• The tap water's PH was testing using an (old...) aquarium PH Tester kit.
  • This utilized a (sodium bromate?, grab the name) liquid that was added in "three drops" to 5ml of the sample (double check data)
  • The resulting color change after mixing was measured utilizing a chart, and a digital phone camera (various exposures, and a flash exposure) (not in RAW, but proprietary apple format, may want to try a version in RAW with better light?)
• That is where i am as of now
• Added ash+charcoal mix ~13:20 EST
• Measured PH ~ ?