Talk:CEB Press/Manufacturing Instructions/Hopper sheet metal: Difference between revisions
Jump to navigation
Jump to search
(Created page with "probly should name page "hopper pannels"") |
(→hole locations: new section) |
||
| (3 intermediate revisions by 3 users not shown) | |||
| Line 1: | Line 1: | ||
probly should name page "hopper pannels" | probly should name page "hopper pannels" | ||
== Using subpages == | |||
Maybe we should use subpages (which I have just enabled so that we can have better support for [[Talk:Translation|translated pages]], as suggested by [[User:sourinux|sourinux]]) for the CEB Press Fab Guide, like: | |||
* [[CEB Press Fab Guide]] (this is the main page) | |||
* [[CEB Press Fab Guide/Hopper sheet metal]] (a subpage) | |||
--[[User:Elifarley|Elifarley]] 16:28, 7 March 2011 (PST) | |||
== hole locations == | |||
based on chris's model, i found that the holes for the back supports need to be 18.5" apart for the holes on the supports to be centered. --[[User:Dorkmo|Dorkmo]] 04:58, 30 September 2011 (CEST) | |||
Latest revision as of 02:58, 30 September 2011
probly should name page "hopper pannels"
Using subpages
Maybe we should use subpages (which I have just enabled so that we can have better support for translated pages, as suggested by sourinux) for the CEB Press Fab Guide, like:
- CEB Press Fab Guide (this is the main page)
- CEB Press Fab Guide/Hopper sheet metal (a subpage)
--Elifarley 16:28, 7 March 2011 (PST)
hole locations
based on chris's model, i found that the holes for the back supports need to be 18.5" apart for the holes on the supports to be centered. --Dorkmo 04:58, 30 September 2011 (CEST)