Revision as of 07:33, 24 June 2013

Introduction

These parts make:

one set of 3" shaft wheel units - for trucktor
one set of 1-7/8" shaft wheel units - for microtrac or bulldozer
One set of gear reduction units - for Bulldozer. Bulldozer uses 1-7/8" drive and 3" gear reduction.
2 idler wheels for Microtrac

92 parts total - Complete DXFs here - File:Hillparts.zip. Quantities of specific part below:

For geardown from here on, not shown above, see James_Log#Tue_Jun_18.2C_2013) - -

(note: appears there are 4 too many of the 3" hole plates for geardown)

@@ Line 38: / Line 38: @@
 *[4] Part 21 - Trucktor Motor Interface Plate - [[File:trucktorinterface.dxf]] - [[File:trucktorinterface.jpg|80px]]
 *[8] Part 22 - Bobcat Standard Quick Attach Standard - [[File:Bobcatstandard.dxf]] - [[Image:bobcatstandard.jpg|100px]]
-*[
+*[7] Part 23 - Dozer Rib 1 - [[File:drib1.dxf]] - [[Image:drib1.jpg|100px]]
+*[7] Part 24 - Dozer Rib 2 - [[File:drib2.dxf]] - [[Image:drib2.jpg|100px]]
+*[7] Part 25 - Dozer Pivot - [[File:dpivot.dxf]] - [[Image:dpivot.jpg|100px]]
+*[7] Part 26 - Dozer Pivot - [[File:dpivot.dxf]] - [[Image:dpivot.jpg|100px]]
+*[7] Part 27 - Dozer Pivot - [[File:dpivot.dxf]] - [[Image:dpivot.jpg|100px]]
 [[Image:DozerBladeandribDFX.PNG|x300px|June 18, 2013]]