Mike Hill Modular Wheel Units Order: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
Line 33: Line 33:


==Parts Addendum==
==Parts Addendum==
[[ File:Hillparts2.zip]] - parts 18-32
*[4] Part 18 - Sprocket - [[File:45T325bore1by8cut.dxf]] - [[Image:sprocketwhubcut.jpg|80px]]
*[4] Part 18 - Sprocket - [[File:45T325bore1by8cut.dxf]] - [[Image:sprocketwhubcut.jpg|80px]]
*[8] Part 19 - Hub Plate - [[File:3hubplate.dxf]] - [[Image:3hubplate.jpg|80px]]
*[8] Part 19 - Hub Plate - [[File:3hubplate.dxf]] - [[Image:3hubplate.jpg|80px]]

Revision as of 09:11, 24 June 2013

Introduction

These parts make:

  • one set of 3" shaft wheel units - for trucktor
  • one set of 1-7/8" shaft wheel units - for microtrac or bulldozer
  • One set of gear reduction units - for Bulldozer. Bulldozer uses 1-7/8" drive and 3" gear reduction.
  • 2 idler wheels for Microtrac

Parts

edit

92 parts total - Complete DXFs here - File:Hillparts.zip. Quantities of specific part below:

For geardown from here on, not shown above, see James_Log#Tue_Jun_18.2C_2013) - Geardownview.jpg -

Parts Addendum

File:Hillparts2.zip - parts 18-32

Summary

(note: appears there are 4 too many of the 3" hole plates for geardown) Thisorder.jpg

File:Thisorder.dxf

Mikecuts.jpg

Individual Views

Images

  • [4] Part 1 - Wheelpart1dxf.jpg
  • [8] Part 2 - Wheelpart2dxf.jpg
  • [4] Part 3 - Wheelpart3dxf.jpg
  • [8] Part 4 - Wheelpart4dxf.jpg
  • [10] Part 5 - Wheelpart5dxf.jpg
  • [2] Part 6 - Wheelpart6dxf.jpg
  • [10] Part 7 - Wheelpart7dxf.jpg
  • [14] Part 8 - Wheelpart8dxf.jpg
  • [2] Part 9 - Wheelpart9dxf.jpg
  • [10] Part 10 - Wheelpart10dxf.jpg
  • [10] Part 11 - Wheelpart11dxf.jpg