Heater Construction Set: Difference between revisions
Jump to navigation
Jump to search
(Created page with "600W modular system is used in 3D printers. Can be scaled readily to multiple elements. 1800W is used in D3D_v20.04.27_Build_Instructions#Heater. Practical limits are as...") |
(Brought Everyone Up to Speed on What I Just Did) |
||
| (One intermediate revision by the same user not shown) | |||
| Line 4: | Line 4: | ||
V=IR -> I=V/R -> P=IV=V^2/R | V=IR -> I=V/R -> P=IV=V^2/R | ||
[[Modular Heatblock]] - remember there already being a page for this or something? found it: "Scalable Heater Block" | |||
Latest revision as of 20:49, 19 May 2020
600W modular system is used in 3D printers. Can be scaled readily to multiple elements. 1800W is used in D3D_v20.04.27_Build_Instructions#Heater.
Practical limits are as much power as is available from outlets, in units of 600W. Other power units can be developed readily, the limit being the melting temperature of the fiberglass sleeving.
V=IR -> I=V/R -> P=IV=V^2/R
Modular Heatblock - remember there already being a page for this or something? found it: "Scalable Heater Block"