Latest revision as of 03:52, 8 February 2026

Online Instructionals

Complete video including flex pvc on wires, bending, cutting with tubing cutter, no line bender needed if you route coolant lines effectively. [1]

This is doc taken from SH4-4 and Sh4-5 build docs and put into one document:

Proper install means you cut the line set to the correct length, otherwise you would coil them up (oil sump issues) or run them extra length just to use up the available length (unsightly and time consuming) [2]. If you cut lines, you may need to add or remove precharged refrigerant.
Outdoor unit may be higher or lower than indoor unit [3]
Floor-mounted unit mounted high on wall? Yes - see Answered Questions by user Dan Mueller [4]

@@ Line 8: / Line 8: @@
 [https://docs.google.com/presentation/d/1YF44L9WZ75y9LLAr8AwxbeC-K__OKJVt7FZzvzeQQ6Y/edit#slide=id.g239a841a92e_0_44 edit]
-=[[Heat Pump Line Evacuation and Refrigerant Release]]=
+=Heat Pump Line Evacuation and Refrigerant Release=
+This is doc taken from SH4-4  and Sh4-5 build docs and put into one document:
+[[Heat Pump Line Evacuation and Refrigerant Release]]
 =OSE Installs=
@@ Line 28: / Line 32: @@
 *[[Heat Pump]]
 *[[Senville Aura]]
+*Heat pumps - initial concpepts doc - [https://docs.google.com/presentation/d/15mYKFucL57P8U_dvaXIhAW36M7y_NE7EAeoDSx3XvC0/edit?slide=id.ga2b61afa46_2_1#slide=id.ga2b61afa46_2_1]
 [[Category: HVAC]] [[Category: Instructions]] [[Category: Instructionals]]