LifeTrac III/Manufacturing Instructions/Assemble: Difference between revisions

Latest revision as of 18:06, 25 January 2012

LifeTrac
Home \| Research & Development \| Bill of Materials \| Manufacturing Instructions \| User's Manual \| User Reviews

@@ Line 1: / Line 1: @@
-{{LifeTracFab}}
+{{ToolTemplate|ToolName=LifeTrac}}
+{{LifeTrac Manufacturing Instructions Navbox}}
 ==Topics==
 [[LifeTrac Fab Assemble|'''Assemble''']]
-:*Frame
+:*[[LifeTrac/Manufacturing Instructions/Assemble/Frame | Frame]]
-:*Arm
+:*[[LifeTrac/Manufacturing Instructions/Assemble/Arms | Arms]]
-:*Hydraulics
+:*[[LifeTrac/Manufacturing Instructions/Assemble/Hydraulics | Hydraulics]]
-==Frame==
-Tools:
-*Jig
-*Blocks
-*Bolting
-**Crescent Wrench
-**Wrench (size)
-**Ratchet (size)
-Materials:
-*Frame Pieces 16x
-*Bolts
-*Washers
-*Nuts
-*Drill/Reamer
-*Level
-*Square/Triangle
-Steps:
-*Setup
-**Allocate Bolts
-***Lay out ??? bolts on Assembly Table
-***Place two washers on each bolt
-***Loosely attach nuts.
-*Note:
-**When mounting/bolting pieces, do so loosely. And tighten afterward.
-*'''Assembly'''
-*Place Blocks on assembly area ground
-*Place Lower Frame pieces (front-to-back) on Blocks
-*Place Lower Frame crossbraces atop the front-to-back pieces
-*Align holes
-*Bolt Lower Frame together.
-*Level the Lower Frame by adjusting Blocks
-*Mount Vertical Frame Pieces to Lower Frame inner corners
-*Mount Upper Crossbrace Frame Pieces
-*Mount Upper Front-Back Frame Pieces
-*'''Squaring'''
-Tighten
-Potential Issues:
-*Bolt not going through?
-*S
-==Arm==