|
|
| (21 intermediate revisions by 2 users not shown) |
| Line 1: |
Line 1: |
| {{LifeTracFab}} | | {{ToolTemplate|ToolName=LifeTrac}} |
| | {{LifeTrac Manufacturing Instructions Navbox}} |
|
| |
|
| ==Topics== | | ==Topics== |
|
| |
|
| [[LifeTrac Fab Assemble|'''Assemble''']] | | [[LifeTrac Fab Assemble|'''Assemble''']] |
| :*Frame | | :*[[LifeTrac/Manufacturing Instructions/Assemble/Frame | Frame]] |
| :*Arm | | :*[[LifeTrac/Manufacturing Instructions/Assemble/Arms | Arms]] |
| :*Hydraulics
| | :*[[LifeTrac/Manufacturing Instructions/Assemble/Hydraulics | Hydraulics]] |
| | |
| | |
| ==Frame==
| |
| ===Tools===
| |
| *Jig
| |
| *Blocks
| |
| *Bolting
| |
| **Crescent Wrench
| |
| **Wrench (size)
| |
| **Ratchet (size)
| |
| *Drill/Reamer
| |
| *Level
| |
| *Square/Triangle
| |
| *Mallet/Hammer
| |
| *Punch
| |
| | |
| ===Materials===
| |
| *Frame Pieces 16x
| |
| *Bolts
| |
| *Washers
| |
| *Nuts
| |
| | |
| ===Steps===
| |
| *'''Setup'''
| |
| **Allocate Bolts
| |
| ***Lay out ??? bolts on Assembly Table | |
| ***Place two washers on each bolt
| |
| ***Loosely attach nuts.
| |
| | |
| *'''Lower Frame Assembly'''
| |
| **Place Blocks on assembly area ground
| |
| **Place Lower Frame pieces (front-to-back) on Blocks
| |
| **Place Lower Frame crossbraces atop the front-to-back pieces
| |
| **Align holes
| |
| **Bolt Lower Frame together.
| |
| **Level the Lower Frame with Level
| |
| ***Adjust Blocks
| |
| | |
| *'''Upper Frame Assembly'''
| |
| **Mount Vertical Frame Pieces to Lower Frame inner corners
| |
| ***Tighten loosely. Leave room for play.
| |
| **Mount Upper Crossbrace Frame Pieces
| |
| **Mount Upper Front-Back Frame Pieces
| |
| **Tighten all frame bolts extra-tight.
| |
| *Finished!
| |
| | |
| ===Potential Issues===
| |
| *Bolt not fitting in hole?
| |
| **Ream hole
| |
| *Bolt fits, but stuck?
| |
| **Loosen nearby bolts, use punch + hammer to force bolt through.
| |
| | |
| ===Successful===
| |
| [[Vann Miller]] | |
| | |
| ==Arm==
| |
