User:Dorkmo/Ideas/Battery: Difference between revisions
< User:Dorkmo | Ideas
Jump to navigation
Jump to search
(→ideas) |
(→bolts) |
||
| Line 56: | Line 56: | ||
**http://www.mcmaster.com/#standard-threaded-rods/=un0kqw | **http://www.mcmaster.com/#standard-threaded-rods/=un0kqw | ||
*bolts | *bolts | ||
**http://www.mcmaster.com/#machine-screws/= | **http://www.mcmaster.com/#machine-screws/=579nk4pdnli2mh6pcm | ||
**http://www.mcmaster.com/#machine-screws/= | **http://www.mcmaster.com/#machine-screws/=579nk4pdnli2mh6334 | ||
*washers | *washers | ||
** | ** | ||
*nuts | *nuts | ||
** | ** | ||
Revision as of 23:40, 17 November 2014
idea is to use loose powder contained in tubs with mesh walls.
design
ideas
- add a couple super capacitors to get some cold cranking amps?
- not sure if that would work but just an idea
- two tubs with grid on four sides of each or shared center.
- fins for surface area.
- cages that snap in to the bottom of a tub shared by two cages.
- might use a part of a sphere for the snap in idea.
- tub lid
- tub lid will need some sort of two pole terminal block
- from cages below
- to next tub or out for use
- might need some sort of cover for uninsulated wires from cage
- vent for gas?
- tub lid will need some sort of two pole terminal block
- need to make parametric for 10 tub battery
- maybe input number of rows and columns so it can be a single row or two side by side
sketches
single cell separated by a grid.
File:BATTERY-idea-20141012.skp
scad work
User:Dorkmo/Ideas/Battery/SCAD
bom
bolts
nickel, aluminum, brass?
- all thread
- bolts
- washers
- nuts