Revision as of 19:53, 4 January 2020

Basics

The Process in Manufacturing and Commerce, where the product/service is examined (Usually with randomly selected samples) to maintain consistent quality, and properties
Also should occur to a lesser degree (ie non destructive testing and benchmarks) at the end of an assembly line

@@ Line 1: / Line 1: @@
-=Sat Aug 31, 2019=
+=Basics=
-*D3D 19.06 - Y2 axix must be constrained only in the Y direction, not X, since that is the auto parallel. The implication is that the linear bearings on Y2 can be loose in the X direction, but not in the Y direction
+*The Process in Manufacturing and Commerce, where the product/service is examined (Usually with randomly selected samples) to maintain consistent quality, and properties
-*Just one electric tape layer around bearing could overtighten the bearings, while without this layer the bearings could be perfectly smooth. -> Even one half layer made it stick.
+*Also should occur to a lesser degree (ie non destructive testing and benchmarks) at the end of an assembly line
-*Y carriage upper bolts are inaccessible without a nut holder tool. Move axis away from frame?
-*Overtightening bolts on lightest drill setting can bend the 20% carriage. Carriage may want to be printed with 40% and highest quality possible.
+=Methods=
-*Temperature overshoot of bed makes you wait a bit of time for temp to drop back down on startup.
+*[[Desttructive Testing]]
-*Smell from rock wool should be eliminated with non off-gasing material
+*[[Non-Destructive Testing]]
+*[[Benchmark Based Testing]]
+=See Also=
+*[[Six Sigma]]
+*[[Quality Assurance]]
+=Useful Links=
+*[https://en.wikipedia.org/wiki/Quality_control The Wikipedia Page on Quality Control]