Bulldozer Specification

• Use same frame as LifeTrac with modifications
  • LifeTrac is 4"x4"x1/4" tubing, the bulldozer should be 4x4x1/2"
• Use 4 Power Cubes for 128 hp of tractor power
  • Use 2 Power Cubes per side to simplify hydraulic plumbing requirements
• 3000 psi hydraulic system pressure
• Cushion Valve on each wheel
• 15,000 inch pound hydraulic motor on each wheel
  • Each wheel has 5-fold gear reduction via Jackshaft
  • Jack shaft uses heavy chain and sprockets
  • Number of jackshafts is 3 for the gearbox; oil-enclosed gear box
• 30 gpm quick couplers on motors, valves, and cylinders
• Use metal wheels as in Traction Engines
• 30" diameter wheels, can be as wide as required to achieve desired traction

• Use 4-flange pillow block bearings with quick-disconnect wheels - see Quick Connect Wheels strategy for LifeTrac
• Use 3" shaft
• 3" bearings - https://www.surpluscenter.com/item.asp?item=1-215-48-4-C&catname=powerTrans
• 4 wheel drive
• Must use bolt-through wheel attachment to shaft as in LifeTrac, u
• Complete materials cost estimate of under $16k in materials, not counting

Challenges

• Low cost ($20/linear foot for jackshaft [x3], sprocket for #100 chain - , chain - $6/foot or 9 feet total

Deployment Suggestions

• 3 separate design challenge for:
  • Main structure - frame, wheels, power cube mounts, hydraulic controls
  • 6-way blade and fabrication procedure, inlcuding fabrication procedure for 8' shop press using 5"x20"x2.5" Cylinders