User talk:AbeAnderson: Difference between revisions
Jump to navigation
Jump to search
(→nesting software: new section) |
|||
| Line 7: | Line 7: | ||
are you having any luck with svgnest? i tried a lot of different methods and had scaling issues and loss of details and other wierd stuff when i tried to convert back to dxf. i was thinking if problems persist it would be possible to run the nesting program and then replicate the output that the program did by hand in freecad. --[[User:Dorkmo|Dorkmo]] ([[User talk:Dorkmo|talk]]) 22:43, 8 October 2017 (CEST) | are you having any luck with svgnest? i tried a lot of different methods and had scaling issues and loss of details and other wierd stuff when i tried to convert back to dxf. i was thinking if problems persist it would be possible to run the nesting program and then replicate the output that the program did by hand in freecad. --[[User:Dorkmo|Dorkmo]] ([[User talk:Dorkmo|talk]]) 22:43, 8 October 2017 (CEST) | ||
also there are some paid nesting services that could be used in the meantime? | |||
Revision as of 20:44, 8 October 2017
Welcome to Open Source Ecology! We hope you will contribute much and well. You will probably want to read the help pages. Again, welcome and have fun! Marcin (talk) 22:03, 27 August 2016 (CEST)
nesting software
are you having any luck with svgnest? i tried a lot of different methods and had scaling issues and loss of details and other wierd stuff when i tried to convert back to dxf. i was thinking if problems persist it would be possible to run the nesting program and then replicate the output that the program did by hand in freecad. --Dorkmo (talk) 22:43, 8 October 2017 (CEST)
also there are some paid nesting services that could be used in the meantime?