Talk:MicroTrac Controller v17.10/Code

Code Examples

• http://www.doctormonk.com/2012/05/sparkfun-venus-gps-and-arduino.html
  • uses arduino's pin 10 for software serial

• https://www.jeremyblum.com/2011/02/27/arduino-tutorial-9-wireless-communication/

ideas

• use capital letter for relay ON and lower case letter for OFF.
• transmit continuous stream of current switch settings
• shut down if stream times out
• remote box could request gps coordinates by sending a "?"
  • onboard could resond "¿" when ready
  • remote will pause stream, onboard will broadcast gps, then continue.

notes

"The Arduino Mega has three additional serial ports: Serial1 on pins 19 (RX) and 18 (TX), Serial2 on pins 17 (RX) and 16 (TX), Serial3 on pins 15 (RX) and 14 (TX)."

xbee uses standard TX RX on arduino, GPS uses serial too will need 19 and 18

controller setup loop

setup

enter AT command mode

print "+++"

set network ID

read EEPROM setting

ATID0x909

set destination address

controller loops

loop

read pin for LF (left track forward)

if HIGH

add "A" to string

otherwise add "a"

...

add timout time value "n" to string

if n = 8

n = 1

else n ++;

transmit string

print to serial

IDs and Networks

• network number 9090
• controller number 9091
• onboard number 9092