Industrial Robot/Manufacturing Instructions

---

Open Section Fabrication and Assembly

Structure

Foundation

• [2] Main tubes

• [2] Support tubes

• [4] Raising Bars

• • Drill 3 holes in each bar (redone image TBD)

• [1] Plate
  • Drill 13 holes (redone image)

• [12] Bolts

• [4] Bolts

• [4] Bolts

Main Arm

• [1] Bar
  • Drill 18 holes

• [8] Bolts

• [8] Bolts

Forearm

• Perpendicular Plate
  • Drill 9 holes
  • Weld to tube

• Tube

• Parallel Plate
  • Drill 9 holes
  • Weld to tube

• [8] Bolts

• [8] Bolts

Gearbox 1,2

• [1] Angle
  • Drill

• [2] Input Plate
  • Drill
  • Note: Location of mounting holes for hydraulic motor unknown

• [4] Side Plate
  • Drill

• [2]Cover Plates
  • Drill

• [4] Outer Race Plate
  • Torch
  • Drill

• [2] Output Hub
  • Turn
  • Drill

• [2] Support Hub
  • Turn

• [2] Output Shaft
  • Grind
  • Drill
  • Tap

• [4] Inner Race
  • Turn
  • Drill

Gearbox 3,4

Forearm Angle

• As shown below

Wrist Angle

• As shown below

Gearbox 3,4,5,6 Input Plate

• Note: Location of mounting holes for hydraulic motor unknown

Gearbox 3,4,5,6 Side Plates

Gearbox 3,4,5,6 Cover Plates

Gearbox 3,4,5,6 Outer Race Plate

Gearbox 3,4,5,6 Output Hub

*incorrect picture

Gearbox 3,4,5,6 Output Shaft

• Keyed

Gearbox 3,4,5,6 Inner Race

Encoder Mount

Encoder Mount Support Angle

Encoder Mount Main Angle

Encoder Mount Coupling

Stepper Mount

Stepper Motor Mount Angle

Stepper Motor Mount Plate

Shaft Bar

• As shown below, repeat for a total of 6 bars

Assemble Components

Assemble Gearboxes

Assemble Industrial Robot

• As shown below

Assemble Stepper Motor Mount

• As shown below, repeat for a total of 6 mounts

Connect Components

Hydraulic Connections

• 2 Axes Hydraulic Circuit

• Hydraulic Circuit

Electronic Connections

• As shown below