File:D3D frame assembly guide.fcstd

From Open Source Ecology
Revision as of 14:20, 22 March 2017 by Marcin (talk | contribs)
Jump to navigation Jump to search

D3D_frame_assembly_guide.fcstd(file size: 35 KB, MIME type: application/zip)

Warning: This file type may contain malicious code. By executing it, your system may be compromised.

Notes

  • Initial upload has .2" width.
  • Proper dimensions should be done based on US Steel gauge + Metric steel gauge
  • Design should allow for accuracy
  • Make gap 1/2 mm oversized (0.05")
  • Gap should fit several frame gauges: 14, 12, 11, 10,
  • Make it such that the gap is stepped in the piece so that the same piece can be used for all frame sizes
  • Steel Gauge -

File history

Click on a date/time to view the file as it appeared at that time.

Date/TimeDimensionsUserComment
current03:18, 23 March 2017 (35 KB)Polemidis (talk | contribs)steps for different gauges cut corner
12:53, 21 March 2017 (15 KB)Polemidis (talk | contribs)

The following page uses this file: