Hot Dip Galvanizing
Jump to navigation
Jump to search
About
- Kettles - copper causes premature kettle failure.
- Kettle manufacturer - [1]
- Materials engineered for use in galvanizing operations - the specific property required is
- Wikipedia - [2]
- Zinc Ammonium Chloride - used as flux - [3]. Zaclon in Ohio makes it. [4]
- Coating thickness for 1/4" and above steel is 85 microns minimum. [5]
- Kettle inspections - tests wall thickness - apparently for wear and complete loss of metal. Wall thickness is measured ultrasonically in situ o a working kettle with molten metal. [6]
- Melting zinc - you can even melt on stovetop, here is a tiny wad of zinc melted into a mini-ingot [7]
Process
From [8]
Howto
- Sand blast
- Base bath - 10 minutes min
- Base bath - 7 minutes min
- Flux - ammonium
- Actual dip - 3.5 minutes (until base metal reaches melt temp of 835F)
- Water - trapped water explodes, and is dangerous, so first dip is dangerous and venting must be assured.
- Zinc - 2400 lb blocks are the feedstock for hot dip baths. This is only 0.1 cubic meter - or 4 cubic feet.
https://www.aisc.org/globalassets/modern-steel/archives/2014/08/2014v08_galvanizing.pdf
More about surface preparation: [9]
Sourcing
- Acid -
- Base - KOH pr NaOH for grease - [10], NaOH doesn't require hot water.
- Ammonium chloride - $2/lb [11]
Zinc Ingots
See Zinc#Sourcing
- [12]
- Carter Alloys, 2" zinc balls [13]
- ACI - [14]
- Ney - [15]
- Industrial Metal Supply - [16]. Do they have ingot?
- Victory - [17]
- Milward - [18]
- Umicore - [19]
- Belmont Brooklyn - [20]
- AEM says zinc - [21]
- Ingots on Thomas Register - [22]
- Zinc Ingot on Thomas Register - [23]
- Zinc on Thomas Register - [24]