Babystepped Z Axis to get better alignment to build plate
Dual end stops?
Mechanical vs Optical vs Magnetic
August 22, 2021
Y axis working again after filing down heated bed carriage piece. Belt was grinding against rough edges inside.
Thinking about printer build ergonomics
Y end stop doesn't remain in place, need to continually readjust but works otherwise.
Printer lowers down too far when printing and nozzle crashes into print bed. Z offset has been adjusted per Ken's recommendation but still not able to get good prints.
Switched to positive end and printer is far enough away to print. Need to refine.
Filament leaks through nozzle even when Extruder is not engaged. Possibly need to replace the nozzle.
Will switch one Z axis rod as the other previously swapped out was too short but now this one is too long and I cannot attach Spool Holder.
Extruder wires seem to be reversed. The causes the printer to send out filament rather than take it in during print.
Extruder behavior corrected by swapping wires.
Need to adjust X/Y axis offsets. Printer prints off of the bed.
July 2021
July 10, 2021
Look into feasibility of moving into FreeCAD 19
Need to updated instructionals
Standing up project management infrastructure
July 3, 2021
HeroX Challenge Collaboration
Business Case Study
To Do
Look into possible media wiki extension for tracking hours log
Send requested materials to access Dev VPN
July 2, 2021
Began building Eco-home modules
Design Lessons
July 1, 2021
Began apprenticeship, clearing workshop and design lessons
June 2021
Thu Jun 24, 2021
Filled out Apprenticeship Survey
Updated Intentional Communities Page
Fri June 18, 2021
Fider is up and working after learning more about Docker.
Need to finish setting up mail server and purging DB instance before testing.
Shipping Tools/Equipment/QoL Items to site
Researching viability of moving certain workloads to containerized environment
