LifeTrac III/Manufacturing Instructions/Assemble/Arms
< LifeTrac III | Manufacturing Instructions | Assemble(Redirected from LifeTrac Fab Assemble Arms)
Assemble | ||
---|---|---|
Frame - Arms - Hydraulics |
Arms
Tools
- Jack
- Wrench
- Crescent Wrench
- WD-40
- Punch
- Mallet
- Hammer
Materials
- Arm Tubes (2x)
- Arm Hydraulic Mount Plates (4x)
- Frame Arm Mounts (2x)
- Rotational Shaft
- Crossbrace
- Crossbrace Mounts (4x)
- QA Plate
- Hydraulic Cylinders
- Short 2x
- Long 2x
- Locking Pins
- Hydraulic Pins 10x
- Cotter Pins 10x
Safety
- The arm and frame are HEAVY. ??? tons
- Be very cautious
- Wear steel toed boots
- Block wheels
Steps
- Lay Arm Tubes on Lifetrac Frame
- Place QA Plate on ground in front of arms.
- Lift Arms into position
- Insert Rotational Shaft through arms and Upper Frame Collars.
- Lay Arm Crossbrace between arms, on Lower Frame front.
- Bolt Crossbrace Mounts to Crossbrace
- Bolt Crossbrace Mounts to Arms (4x)
- Connect Arms to QA plate.
- Insert Pins
- Bolt Hydraulic Mount Plates to Arms (4x)
- Attach Hydraulic Arm Frame Mounts to Arms(2x)
- Mount Main Hydraulic Cylinders (2x) between Frame Mount and Arm Plates
- Insert Pins
- Mount Secondary Hydraulic Cylinders (2x) between QA plate and Arm Plates
- Insert Pins
- Insert Cotter Pins into all Pins
Issues
- Arm Rotation Shaft not going through?
- Grind shaft
- Ream holes
- Pins not fitting in hydraulic holes?
- Grind pins
- Collars come loose?
- Mallet, Punch, WD-40
|