Latest revision as of 22:07, 18 September 2020

Production Engineering

D3D v19.06 3 - using 1 mm nozzle.
Custom Profile - File:D3D1906 3 leftcorner.ini
- (note that FeF Microfactory has generic profile) - cuts off 5 mm at bottom. No brim.

In cold temp - 11C - extruder goes up only to 230C, and that is only at 33% of the above profile. Extruder does have a sock.
Print came off the bed at 80C bed, winter profile has 100C bed and 8 lines of brim.

D3D v19.06 2 - File:D3d1906 2 corner custom.ini. 0.4 mm nozzle.
- 9 hours 19 min, 104 grams

Click on a date/time to view the file as it appeared at that time.

	Date/Time	Dimensions	User	Comment
current	22:07, 18 September 2020	(82 KB)	Marcin (talk \| contribs)	Dummy file.
	22:06, 18 September 2020	(82 KB)	Marcin (talk \| contribs)	105% for easier fit.
	04:03, 31 October 2019	(82 KB)	Marcin (talk \| contribs)	In position for printing. Note that 5 mm cut off at bottom comes from profile.
	00:29, 31 October 2019	(82 KB)	Marcin (talk \| contribs)

You cannot overwrite this file.

The following 4 pages use this file:

@@ Line 1: / Line 1: @@
 =Production Engineering=
+==1 mm==
 *[[D3D v19.06]] 3 - using 1 mm nozzle.
 *Custom Profile - [[File:D3D1906_3_leftcorner.ini]]
@@ Line 5: / Line 6: @@
 [[File:leftcorner_prod_eng.png]]
+===Notes===
+*In cold temp - 11C - extruder goes up only to 230C, and that is only at 33% of the above profile. Extruder does have a sock.
+*Print came off the bed at 80C bed, winter profile has 100C bed and 8 lines of brim.
+==0.4 mm==
+*[[D3D v19.06]] 2 - [[File:d3d1906_2_corner_custom.ini]]. 0.4 mm nozzle.
+**9 hours 19 min, 104 grams