CEB Press/Manufacturing Instructions/Detroit Fab Lab Solenoid Driver v2: Difference between revisions
| Line 35: | Line 35: | ||
=Upgrades= | =Upgrades= | ||
Field testing at Factor e Farm in 2011 has shown that twigs and rocks can jam the soil loading drawer if these are not crushed by the scissor action of the drawer as actuated by 7the secondary cylinder. In the case of a jam, we uploaded | Field testing at Factor e Farm in 2011 has shown that twigs and rocks can jam the soil loading drawer if these are not crushed by the scissor action of the drawer as actuated by 7the secondary cylinder. In the case of a jam, we uploaded the CEB testing code interface to move the drawer by computer control via USB cable. This is time consuming, so the next iteration should include manual bypass toggles on the controller board itself, so the user can mive the drawer manually as needed. This applies to both the primary and secondary cylinder. | ||
To do this, a simple togle switch such as the reset switch should be placed between the gruond | |||
Revision as of 22:12, 2 December 2011
put sensor terminals on detroit board
http://opensourceecology.org/wiki/File:Detroit2print.png
http://sketchup.google.com/3dwarehouse/details?mid=10a3722997daf166b38804396e417a9b
General Processes/Circuit Etching
bug
i found a bug today. there needs to be a connection from the 12v line to the VIN pin next to the ground pin the sensors are connected to. will update drawings when i get the chance. --Dorkmo 21:37, 3 November 2011 (CET)
- k updated --Dorkmo 00:49, 12 November 2011 (CET)
Finished Board
Note: jumper not needed, already corrected in board image for pcb etching.
Upgrades
Field testing at Factor e Farm in 2011 has shown that twigs and rocks can jam the soil loading drawer if these are not crushed by the scissor action of the drawer as actuated by 7the secondary cylinder. In the case of a jam, we uploaded the CEB testing code interface to move the drawer by computer control via USB cable. This is time consuming, so the next iteration should include manual bypass toggles on the controller board itself, so the user can mive the drawer manually as needed. This applies to both the primary and secondary cylinder.
To do this, a simple togle switch such as the reset switch should be placed between the gruond