LifeTrac IV/Manufacturing Instructions: Difference between revisions

From Open Source Ecology
Jump to navigation Jump to search
 
(5 intermediate revisions by the same user not shown)
Line 23: Line 23:
=Parts manufacture=
=Parts manufacture=


[[LifeTrac IV/Manufacturing Instructions/Frame]]
*[[LifeTrac IV/Manufacturing Instructions/Frame|Frame]]
==Frame==
*[[LifeTrac IV/Manufacturing Instructions/Arms|Arms]]
===cut===
*[[LifeTrac IV/Manufacturing Instructions/Quick Attach Plate|Quick Attach Plate]]
4"X4"X1/4" Square Tubing
*[[LifeTrac IV/Manufacturing Instructions/Wheel Mount|Wheel Mount]]
*Four 76"
*Two 68"
*Three 60"
*Two 59"
*Two 55"
*Two 52"
*Three 44"
 
===drill===
 
* Unless otherwise specified, drill all holes at 13/16" diameter.
* Drill holes through entire tube (ie: through both sides).
* For each tube, measure all holes from one end of tube.
 
----
 
; 3 Lower cross tubes, 60" long
: Drill holes at 14", 46"
: Rotate 90 degrees, drill holes at 2", 10", 50", 58"
 
; 2 Bottom Inner North-South tubes, 76" long
: Drill holes at 6", ? 70"
: Rotate 90 degrees, drill holes at 2", ? 50", 58"
 
; 2 Bottom Outer North-South tubes, 76" long
: Drill holes at ?
: Rotate 90 degrees, drill holes at 2", ? 74"
 
; 2 Front Vertical tubes, 55" long
: Drill holes at 6", 50"
: Rotate 90 degrees, drill holes at 2", 46"
 
; 2 Middle Vertical tubes, 52" long
: Drill holes at 6", 24", 50"
: Rotate 90 degrees, drill holes at 2", 46"
 
; 2 Rear Vertical tubes, 59" long
: Drill holes at 2", 21", 29 1/2", 47 1/2", 54"
: Rotate 90 degrees, drill holes at 6", 50"
 
; 2 Top North-South tubes, 68" long
: Drill holes at 6", 22", 62"
: Rotate 90 degrees, drill holes at 2", 26", 66" and a 2 3/8" hole @ 48" (with cutting torch)
 
; 3 Top Cross tubes, 44" long
: Drill holes at 6", 38"
: Rotate 90 degrees, drill holes at 2", 42"
 
==Arms==
===cut===
===drill===
===weld===
 
 
==Wheel Mounts==
===cut===
===drill===
===weld===


=Assemble=
=Assemble=


==Bolts==
==Bolts==
==Attach Arms==


==paint==
==paint==

Latest revision as of 21:34, 19 March 2012

Introduction

Documents

Preparation

workspace, safety

Tools

  • Torch
  • Welder
  • Saw
  • Mag Drill
  • 3/4"
  • 13/16"


Bill Of Materials

Parts manufacture

Assemble

Bolts

Attach Arms

paint

hydraulics

Quality Check

Updates

Retrieved from "https://wiki.opensourceecology.org/index.php?title=LifeTrac_IV/Manufacturing_Instructions&oldid=56816"