D3D Competitors Comparison: Difference between revisions
| Line 30: | Line 30: | ||
= D3D Universal = | = D3D Universal = | ||
'''TODO:''' Replace with table comparison D3D Universal to comparable open-source competitor models. | '''TODO:''' Replace with table comparison of D3D Universal to comparable open-source competitor models. | ||
= See Also = | = See Also = | ||
Revision as of 04:44, 17 April 2020
Introduction
The goal of this page is to compare and contrast common D3D Printer models with competitor models.
Of particular interest are open-source competitor models.
If this page gets complex enough, then breaking out each model into a separate page may be warranted leaving this page as an index.
Potential Comparison Products
VERY low end
- TEasyThreed X1 a ~100 USD Printer
NOTE: This section is more relevant to low-income people, or people living in third-world or developing countries. We currently don't have a version of the D3D targeted for this segment of the population, but maybe we could (e.g. the D3D Free, D3D Cheap, D3D Low-Cost etc.) .
Low End
- Ender 3
- CR-10 etc
- Various clones of clones of clones on alibaba etc
- Prusa Mini (Similar to d3d universal in structure)
Entusiast/Prosumer
"Pro"
- Ultimaker?
- Makerforged
D3D Pro
TODO: Replace with table comparison of D3D Pro to comparable open-source competitor models.
D3D Universal
TODO: Replace with table comparison of D3D Universal to comparable open-source competitor models.