CoolRAMPS: Difference between revisions
No edit summary |
No edit summary |
||
| Line 1: | Line 1: | ||
Page edited by [[Image:marcinted.jpg|80px]], with CNC Torch Table [[Image:CNC Torch Table.png|80px]] design by [[Image:repraplogo.png|80px]][[RepRap]] open source community with adherence to [[Image:oshwalogo.png|60px]] and | Page edited by [[Image:marcinted.jpg|80px]], with CNC Torch Table [[Image:CNC Torch Table.png|80px]] design by [[Image:logobw.jpg|100px]] building upon the work of [[Image:repraplogo.png|80px]][[RepRap]] open source community with adherence to [[Image:oshwalogo.png|60px]] and | ||
=Overview= | =Overview= | ||
Revision as of 22:04, 14 June 2013
Page edited by 
, with CNC Torch Table 
design by 
building upon the work of 
RepRap open source community with adherence to 
and
Overview
We are building on open source electronics from the RepRap project to build the OSE CNC Torch Table, until we develop our own higher power controllers within the framework of the Power Electronics Construction Set.
Technical
Credits to Kliment for developing Cool DRV (care of #Bubblerep which we are using with RepRap Generation 4 RAMPS electronics to run steppers with microstepping. We are using Xylotex 425 oz in Stepper Motors, which are rated for 2.8A max. We will run the system at partial power until we develop the Scalable Open Source Stepper Motor Controller, possibly by making improvements upon the Powerlolu GPLv2 electronics from the [[