Fermentor design

| Dialysis Fermentor Systems for Concentrated Culture of Microorganisms by Gallup and Gerhardt (1963) describes a fermentor connected to a dialysis unit that allowed extremely high cell density and other favorable features. The semipermeable membrane was made of regenerated cellulose and held taut in a frame in a separate chamber.. Feeding could be conducted by exchange at the membrane. Extremely high cell density was achieved with the Serratia marcescens culture. When a reservoir chamber was used to with dialysis tubing a second phase to the growth phase was introduced. Addition of polyethylene glycol can drive the water from a culture and cause them to flocculate (and can clog a machine).

Low-Cost Microbioreactor for High-Throughput Bioprocessing by Kostov et al (2000) details a design for a 2 ml microbioreactor and an optical system to detect the pH, dissolved oxygen (DO), and optical density (OD600, OD). The behavior of the microreactor was compared with a standard laboratory grade 1 liter bioreactor.

To measure pH the ratiometric pH-sensitive dye: 1-hydroxypyrene-3,5,7-sulfonic acid was added to the media. The dye has two excitation peaks, 400 and 450 nm, and an emission peak at 520 nm. The ratio of the excitation from 400 nm and 450 nm shifts based upon pH allowing for measurement of pH. A blue led and UV led are used to excite the longer and shorter excitation wavelengths respectively, and the 520 nm emission wavelength was measured with a large active area PIN photodiode with a filter for 520 +/- 5 nm. A calibration curve of the instrument was prepared in sterile media adjusted with 1 M HCl or NaOH and a pH meter. This is an interesting demonstration which could be adapted to quantifying GFP labeled protein products, however the inclusion of a dye in the growth media is undesirable and a method for immobilizing the dye would be a necessary further step.

Dissolved oxygen was quantified via quenching by O2 of fluorescence of a ruthenium-based oxygen sensor, Ru(diphenylphenanthroline)3 2+. A blue led 460 ± 15 nm filter was used for excitation and emissions measured with an avalanche photodiode module with a mounted 590 ± 20 nm bandpass interference filter. The phase delay of electronics was measured by referencing the red led of the optical density detector. A calibration curve was prepared using a controlled combination of nitrogen and atmospheric air.

Optical density was measured with a red ultra-bright led and a photodetector (PIN photodiode coupled to transimpedance amplifier) with an interference filter at 600 ± 5 nm. Output measurements were measured from the analog to digital converter board. The OD measurements are not linear to Beer's law and accurate measurements up to OD 9 are possible.

Fermentor for E. coli protein expression:
http://www.biotechniques.com/BiotechniquesJournal/2008/August/An-automated-home-built-low-cost-fermenter-suitable-for-large-scale-bacterial-expression-of-proteins-in-Escherichia-coli/biotechniques-45258.html Supplementary contains build instructions and bill of materials: http://www.biotechniques.com/multimedia/archive/00041/318_41920a.pdf

http://www.coe.neu.edu/Depts/test/MIE/pdfs/Capstone/Mechanical_Engineering/ME%202010%2012%20Bioreactor%20to%20Enable%20Microbe%20Productivity%20Optimiz.pdf

https://biogas.ifas.ufl.edu/Publs/BioresourTechnol-92(1)-2004.pdf

http://www.sky.cz/lambda/pdf/bioreactors-article.pdf

http://pac.iupac.org/publications/pac/pdf/1973/pdf/3603x0305.pdf

http://chem.engr.utc.edu/ench435/2004/FromTablet/FILTER-AIDS.pdf