Rototiller/Manufacturing Instructions/Bucket: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 8: | Line 8: | ||
=Part Fabrication= | =Part Fabrication= | ||
{| class="wikitable sortable" | |||
|+ Parts List | |||
|- | |||
| align="center" |'''ITEM NO.''' | |||
| align="center" |'''PART NUMBER''' | |||
| align="center" |'''QTY.''' | |||
|- | |||
| 1||Blade||1 | |||
|- | |||
| 2||Skid Plate||2 | |||
|- | |||
| 3||Bottom Plate||1 | |||
|- | |||
| 4||Side Plates||2 | |||
|- | |||
| 5||Side Brace Plate||2 | |||
|- | |||
| 6||Hard Stop Plate||2 | |||
|- | |||
| 7||Triangle Plate||2 | |||
|- | |||
| 8||Cross support plate||1 | |||
|- | |||
| 9||Cross support Plate Lower||1 | |||
|- | |||
| 10||Rear Mounting Plate||1 | |||
|- | |||
| 11||Back Plate||1 | |||
|- | |||
| 12||Bottom Mounting Plates||2 | |||
|- | |||
| 13||Hinge Pipe||4 | |||
|- | |||
| 14||Large Tube Angled||2 | |||
|- | |||
| 15||Hex Nut, 0.75-10, Steel||4 | |||
|- | |||
|} | |||
=Assembly= | =Assembly= | ||
Revision as of 03:42, 17 December 2011
| |||||||||||||||||||
Overview
The bucket is used to collect the dirt as it is chopped up by the spinning tines. It also contains the features that allow the entire assembly to mount to the tractor.
Tools Required
Materials Required
Part Fabrication
| ITEM NO. | PART NUMBER | QTY. |
| 1 | Blade | 1 |
| 2 | Skid Plate | 2 |
| 3 | Bottom Plate | 1 |
| 4 | Side Plates | 2 |
| 5 | Side Brace Plate | 2 |
| 6 | Hard Stop Plate | 2 |
| 7 | Triangle Plate | 2 |
| 8 | Cross support plate | 1 |
| 9 | Cross support Plate Lower | 1 |
| 10 | Rear Mounting Plate | 1 |
| 11 | Back Plate | 1 |
| 12 | Bottom Mounting Plates | 2 |
| 13 | Hinge Pipe | 4 |
| 14 | Large Tube Angled | 2 |
| 15 | Hex Nut, 0.75-10, Steel | 4 |