Rototiller/Manufacturing Instructions/Arm Rest: Difference between revisions
Jump to navigation
Jump to search
| (3 intermediate revisions by the same user not shown) | |||
| Line 16: | Line 16: | ||
! align="center" |'''QTY.''' | ! align="center" |'''QTY.''' | ||
|- | |- | ||
| Square Tubing || 2" x 2" x 0.25"Thick || align="center"|2 | | Square Tubing || 2" x 2" x 0.25"Thick x 13.5"|| align="center"|2 | ||
|- | |- | ||
| Flat || 0.5" x 2" x 4" || align="center"|2 | | Flat || 0.5" x 2" x 4" || align="center"|2 | ||
| Line 28: | Line 28: | ||
! align="center" |'''QTY.''' | ! align="center" |'''QTY.''' | ||
|- | |- | ||
| align="center" |1 || [[ | | align="center" |1 || [[:file:100533.JPG| Small Tube, Arm]] || align="center"|2 | ||
|- | |- | ||
| align="center" |2 || [[ | | align="center" |2 || [[:file:100534.JPG| Plate, Arm Rest]] || align="center"|2 | ||
|} | |} | ||
=Fabrication and Assembly Instructions= | =Fabrication and Assembly Instructions= | ||
| Line 40: | Line 39: | ||
! align="center" |'''QTY.''' | ! align="center" |'''QTY.''' | ||
|- | |- | ||
| [[ | | [[:file:100532.JPG| Arm Rest Welded Assembly]] || align="center"|2 | ||
|} | |} | ||
# Cut piece parts are per drawings | # Cut piece parts are per drawings | ||
# Weld the plate onto the tube all around using the dimensions shown in the assembly drawing | # Weld the plate onto the tube all around using the dimensions shown in the assembly drawing | ||
Latest revision as of 16:46, 23 December 2011
| |||||||||||||||||||
Overview
|
The arm rests acts as a hard stop that sets the level that the shaft and motor frame assembly can go down to. |
Tools Required
Materials Required
| TYPE | SIZE | QTY. |
|---|---|---|
| Square Tubing | 2" x 2" x 0.25"Thick x 13.5" | 2 |
| Flat | 0.5" x 2" x 4" | 2 |
Parts List and Drawings
| ITEM NO. | PART NAME | QTY. |
|---|---|---|
| 1 | Small Tube, Arm | 2 |
| 2 | Plate, Arm Rest | 2 |
Fabrication and Assembly Instructions
| Assembly Name | QTY. |
|---|---|
| Arm Rest Welded Assembly | 2 |
- Cut piece parts are per drawings
- Weld the plate onto the tube all around using the dimensions shown in the assembly drawing