May Production Plan

Strategy:

• List steps in order of duty – Power Cube to Tractor to CEB press
• Assess capacity required and allocate tasks to 6 fabricators and local shop
• List risks and recovery plans
• Assess daily, before and after workday
• Draw up personnel plan, detailed

Power Cube Tasks

See Power Cube Documentation

Build Hydraulic Tank

Build Fuel Tank

Prepare Electrical System Components

Build Mufflers

Assemble Power Cube

Mount Power Cube

Test Power Cube on Tractor

Tractor Tasks

See Tractor Documentation

Assemble H-arms

Mount Loader Arms

Build QA Plate Mounting Eyes

Mount Cylinders

• Drill cylinder mount plate holes in loader arms
• Mount cylinder plates (2 per arm)
• With loader arms in place, arrange bottom and top mounts, drill holes
• Attach main cylinder to arms
• With main cylinder attached, finetune location of bottom cylinder mount for equal extension of cylinders
• Drill bottom mount locations
• Bolt bottom mounts

Main Cylinder Bottom Mounts

• Cut 6x12x1/2 plate
• [2] Cut 4x6x1/2 plate
• Drill or punch 1" hole for pin
• Weld nuts onto [2] plates on outside
• Tack [2] plates about 3.5" apart for cylinder mounting
• Weld with pin in holes (to maintain alignment of pin)

Main Cylinder Top/2nd Cyl Bottom Mounts

• Cut 6x12x1/2" plate
• Drill 4 holes on 2 pin holes on each plate
• Weld 1" drilled out nut onto plates
• Bolt to arms

Wheel Shafts

• Cut 1-7/8" shafts to 28"
• Cut 6" long collars from 2" pipe
• Label collar and shaft, as these are paired up and can't be confused between shafts.
• Drill 3/4" hole for wheel plate mounting through shaft and collar
  • Drill through collar and shaft at the same time
• Weld on reinforcing nuts on collars
• End drill 3.5" deep (on a lathe) the 1-3/8" receiver for 6-spline standard PTO shafting

Wheel Mounting Plates

• Prepare plates, 4 per tractor - 8x10x1/2"
• Download CAM files for wheel plates -[1]
• Configure LinuxCNC
• Torch out plates (or cut by hand)
• Cut gussets - right angle triangles with 4" legs - 4 per wheel
• Weld gussets onto plates

Hydraulic Motor Interface Plates

• Prepare plates, 4 per tractor - 6x8x1/2"
• Download CAM files for interface plates - []
• Torch out plates (or cut by hand)

Hydraulic Motor Mount Plates

• Prepare plates, 4 per tractor, 8x10x1/2"
• Download CAM files -[]
• Torch out plates (or cut by hand)

May Production Run New Generator Tasks

May Production Run Generator Tasks

May Production Run CEB Tasks

May Production Run CEB Tasks