Latest revision as of 21:23, 23 June 2011

@@ Line 31: / Line 31: @@
 See [[Tractor Documentation]]
-'''[[Assemble H-arms]]'''
+'''[[Build Frame]]'''
+'''[[Build QA Plate]]'''
+'''[[Build Wheel Shaft Attachments]]'''
+'''[[Build Wheel Shafts]]'''
-'''[[Mount Loader Arms]]'''
+'''[[Mount Motors]]'''
-'''[[Build QA Plate Mounting Eyes]]'''
+'''[[Mount Wheels]]''' - fabricate wheel mounting plates
-'''[[Build QA Plate]]'''
+'''[[Assemble H-arms]]'''
+'''[[Mount QA Plates]]'''
 '''[[Mount Cylinders]]'''
-=Wheel Shafts=
+Then final assembly:
-*Cut 1-7/8" shafts to 28"
-*Cut 6" long collars from 2" pipe
-*Label collar and shaft, as these are paired up and can't be confused between shafts.
-*Drill 3/4" hole for wheel plate mounting through shaft and collar
-**Drill through collar and shaft at the same time
-*Weld on reinforcing nuts on collars
-*End drill 3.5" deep (on a lathe) the 1-3/8" receiver for 6-spline standard PTO shafting
+'''[[Insert Wheel Shaft Assemblies into Bearings]]'''
-=Wheel Mounting Plates=
+'''[[Build Wheel Motor Assemblies and Mount on Tractor]]'''
-*Prepare plates, 4 per tractor - 8x10x1/2"
-*Download CAM files for wheel plates -[http://openpario.mime.oregonstate.edu/documents/1237]
-*Configure LinuxCNC
-*Torch out plates (or cut by hand)
-*Cut gussets - right angle triangles with 4" legs - 4 per wheel
-*Weld gussets onto plates
 =Hydraulic Motor Interface Plates=
@@ Line 71: / Line 66: @@
 *Torch out plates (or cut by hand)
-=Secondary Cylinder Mount, bottom=
 =May Production Run New Generator Tasks=

May Production Plan: Difference between revisions