CEB Press/Manufacturing Instructions/Grate mounts: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 17: | Line 17: | ||
== Fabrication Steps == | == Fabrication Steps == | ||
#Punch the | #Punch the hole on the bottom of the supports for each. | ||
#Torch away a 4" section on the top of each grate to make it like the model shown. Remember that the two are mirrored. Cut away the corner so the hopper wont hit it, about a 1" 45 degree triangle. | #Torch away a 4" section on the top of each grate to make it like the model shown. Remember that the two are mirrored. Cut away the corner so the hopper wont hit it, about a 1" 45 degree triangle. | ||
#Torch a slot for a 3/4" bolt at the top of the mount, | #Torch a slot for a 3/4" bolt at the top of the mount, as shown. | ||
#Grind away all the slag. | #Grind away all the slag. | ||
Revision as of 23:44, 13 December 2011
| |||||||||||||||||||||||||
The grate mounts attach to the primary arms and to a nut welded to the grate.
Tools Required
- Torch
- Punch with 13/16" Dies
Materials Required
- 4"x4"x1/2" angle: 38" (2)
Diagrams
Fabrication Steps
- Punch the hole on the bottom of the supports for each.
- Torch away a 4" section on the top of each grate to make it like the model shown. Remember that the two are mirrored. Cut away the corner so the hopper wont hit it, about a 1" 45 degree triangle.
- Torch a slot for a 3/4" bolt at the top of the mount, as shown.
- Grind away all the slag.