User:Dorkmo/Log
Dorkmo's Large File Torrent Feed
{{#widget:Feed |feedurl=http://dorkmo.net/osefeeddorkmo.xml |chan=n |num=5 |desc=0 |date=y |targ=n }}
2011 2012 2013 2014 2015 2016 2017
May 20, 2018
- went through measurements in CircularKnitic_Parametric to create diagram of needle location in relation to key parts of structure
- going to use diagram to distill new variables of relationships between needle and strcuture. then use for parametric needle variables in OSE_CircularKnitic_v18.03
April 23, 2018
- just found OpenScad's MCAD, http://reprap.org/wiki/MCAD
- looks like you can make gears quick and easy? need to test it out.
- could be handy for circularknitic
April 22, 2018
- mostly finished with the OSE CircularKnitic v18.03#CKpM.scad "mountain"
- probably some bugs that need tweaking, ill let them suprise me later
- going to slowly build a circularknitic. started a build log User:Dorkmo/Builds/CircularKnitic
- ordered some needles
- need to measure their dimensions before rendering parts that need to be 3dprinted.
- added a few details to the Freezer_to_Refrigerator_Conversion/Manufacturing_Instructions
- plan on doing a fresh build and take pictures each step
Mar 28, 2018
Freezer to Refrigerator Conversion
wired up a test box. having trouble triggering relay. probably not enough signal voltage from microcontroller. need to test output from arduino MKR1000 further. I think i might need a diode with the resistor?
got everything to fit inside a 4x4x2 conduit box. used stepped drill bit to cut holes. then tied knot in wire to keep it from pulling out.
Mar 24, 2018
Added wiring harness for fridge conversion. Tweaked BOM.
Freezer to Refrigerator Conversion
Populated Open Hardware Business Models
Mar 3,2018
- Did the scad model for a needle for fun CircularKnitic_Parametric#Needle_Files
Feb 11, 2018
- worked on CircularKnitic Parametric a little.
- a couple more 3D printed parts to do, then 2D lazer cut parts
Feb 10, 2018
Signed up for Kit.com. Prepping new amazon.com based BOM for Freezer to Refrigerator Conversion.
Feb 3, 2018
Starting a parametric version of CircularKnitic bc i'd like to make a larger format version CircularKnitic Parametric
January 2018
Started MicroTrac Controller v18.02 and LiPo Charger USB v18.02