CEB Press/Manufacturing Instructions/Dirt-Keeper Plate: Difference between revisions
Jump to navigation
Jump to search
| Line 6: | Line 6: | ||
=Materials required= | =Materials required= | ||
*1/8" plate: 28.75"x13.5" | *1/8" plate: 28.75"x13.5" | ||
Note: This can be torched from the leftover plate from the hopper. Its OK if the corners are a bit chopped off, as they will be hidden and out of use under the primary arms. | |||
=Diagrams= | =Diagrams= | ||
Revision as of 21:41, 28 October 2011
Main > Housing and construction > CEB Press > CEB press building instructions
| |||||||||||||||||||||||||
The dirt-keeper plate prevents dirt from falling out of the drawer when it is fully retracted.
Tools required
- Hole punch with 1" dies
Materials required
- 1/8" plate: 28.75"x13.5"
Note: This can be torched from the leftover plate from the hopper. Its OK if the corners are a bit chopped off, as they will be hidden and out of use under the primary arms.
Diagrams
Fabricating instructions
Punch the 1" holes in the proper locations: 1.25" from the 13.5" edge, and 1.75" from the 28.75" side.