CEB Press/Manufacturing Instructions/Arms - secondary: Difference between revisions
Jump to navigation
Jump to search
(Brianna indicated this is complete, so I'm removing the warning for now.) |
m (→Materials Required: Angle Steel: 3/8" -> 1/2") |
||
| Line 13: | Line 13: | ||
== Materials Required == | == Materials Required == | ||
*2 pieces 72" long - 4"x6" | *2 pieces 72" long - 4"x6"x1/2" angle steel | ||
*1 piece 3"x3"x1/2" steel | *1 piece 3"x3"x1/2" steel | ||
*[[CEB Press/Manufacturing Instructions/Leg Holders|Leg Holders]](8) | *[[CEB Press/Manufacturing Instructions/Leg Holders|Leg Holders]](8) | ||
Revision as of 17:42, 30 September 2011
Main > Housing and construction > CEB Press > CEB press building instructions
| |||||||||||||||||||||||||
The secondary arms connect the primary arm/frame assembly to the legs to support the structure.
Tools Required
- Cutting Torch
- Angle Grinder
- Welder
Materials Required
- 2 pieces 72" long - 4"x6"x1/2" angle steel
- 1 piece 3"x3"x1/2" steel
- Leg Holders(8)
Diagrams
Front Arm
Back Arm
Fabrication Steps
see Leg Holders
- Clamp the leg holders in their proper locations (two at each end, and two 12" away from the end) and weld them in place.
- Clamp one angle iron arm to each side of the primary arms, the 6" side to the underside of the primary arms, with the 4" side facing outwards from the assembly.
- Torch thru the holes on the primary arms to make two 3/4" holes on each secondary arm.
- Clean up the torch slag with an angle grinder.