CEB Press/Manufacturing Instructions/Arms - secondary: Difference between revisions
Jump to navigation
Jump to search
| Line 18: | Line 18: | ||
== Diagrams == | == Diagrams == | ||
Note: In the final model, there is only one hole where the secondary arms connect to the primary arms. Please change. | |||
Front Arm | Front Arm | ||
Revision as of 00:54, 5 October 2011
Main > Housing and construction > CEB Press > CEB press building instructions
| |||||||||||||||||||||||||
The secondary arms connect the primary arm/frame assembly to the legs to support the structure.
Tools Required
- Cutting Torch
- Angle Grinder
- Welder
Materials Required
- 2 pieces 72" long - 4"x6"x1/2" angle steel
- 1 piece 3"x3"x1/2" steel
- Leg Holders(8)
Diagrams
Note: In the final model, there is only one hole where the secondary arms connect to the primary arms. Please change.
Front Arm
Back Arm
Fabrication Steps
see Leg Holders
- Clamp the leg holders in their proper locations (two at each end, and two 12" away from the end) and weld them in place.
- You may want to weld them so the nut is facing sideways instead of straight out, this way the bolts don't stick out any more from the machine.
- Put bolts in the outside leg holders on each arm.
- Clamp one angle iron arm to each side of the primary arms, the 6" side to the underside of the primary arms, with the 4" side facing outwards from the assembly.
- Torch thru the holes on the primary arms to make two 3/4" holes on each secondary arm.
- Clean up the torch slag with an angle grinder.