CEB Press/Manufacturing Instructions/Soil grate: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
| Line 3: | Line 3: | ||
== Tools Required == | == Tools Required == | ||
*Welder | |||
*Clamps | |||
*Torch | |||
== Materials Required == | == Materials Required == | ||
| Line 16: | Line 18: | ||
== Fabrication Steps == | == Fabrication Steps == | ||
#Prepare the 6' pieces. One needs nuts welded to it, where it will attach to the grate supports. The other needs holes torched in it where it attaches to the hopper supports. | |||
Revision as of 01:28, 9 October 2011
| |||||||||||||||||||||||||
Warning: The documentation for the CEB Press is undergoing a thorough overhaul. CAD models and written directions are presently obsolete. For more information, see Talk:CEB_Press#Documentation_overhaul_in_progress. When the models, specifications and text on this article have been thoroughly reviewed, updated when necessary, and confirmed as whole and accurate, this warning may be removed.
Tools Required
- Welder
- Clamps
- Torch
Materials Required
- 1/4”x2”x2” angle, 6' (2)
- 1/4”x2”x2” angle, 3' (2)
- 1/4”x2” bar, 71.5”
- 3/8” rebar, 105'
- 3/4" Steel nuts (2)
Diagrams
The grate is 6 by 3 feet (91.4 by 182.9 cm). Made from 33 pieces of half-inch rebar, each three feet in length. These pieces of rebar fit into a frame made of 1/4" angle. There is a one-and-a-half inch between each of the rebars, which means 2 inches from the center of one to the center of the next.
Fabrication Steps
- Prepare the 6' pieces. One needs nuts welded to it, where it will attach to the grate supports. The other needs holes torched in it where it attaches to the hopper supports.