CEB Press/Manufacturing Instructions/Soil Shaker

Warning: The documentation for the CEB Press is undergoing a thorough overhaul. CAD models and written directions are presently obsolete. For more information, see Talk:CEB_Press#Documentation_overhaul_in_progress. When the models, specifications and text on this article have been thoroughly reviewed, updated when necessary, and confirmed as whole and accurate, this warning may be removed.

Materials Required

Steel

• 4"x4"x1/2" Angle:
  • 8" Piece: Motor attachment
  • 21" Piece: Hopper attachment
• 1" Rebar: 8.5" (2): Braces
• 1" DOM Roundstock: 6.5", shaft
• 1"x2" flatbar: 11"

Other

• 1"x2"x5" eccentric pillow bearings with locking eccentrics.
• 1" to 1" coupler to fit motor
• 1/4"x2.5" or 3/8"x2.5" bolt and accompanying nut.
• Hydraulic motor (find specs)

Fabrication Steps

Marking the hole for the shaker motor.

1. Torch a hole for mounting the motor.
   • The center of the hole should be 1 3/4" away from the corner of the angle.
   • You need to ensure the hole is large enough so that where the bolt holes are will be touching the angle when in place. The motor is most likely raised in the center.
   • You can torch separate holes for the bolts, or do one large, odd shaped one like is pictured.